Original how to use the Urinator video !
Transcript of the above video.
If you would rather read the instructions.
- Using The Urinator
- Mix your concentrated urine sample with approximately 75 mL or 22 o of warm water
- Remove the cap from the end of the fluid bag and remove the cap from the end of the syringe.
- Using the syringe place the urine sample Into The Urinator.
- You can always use someone else’s sample in The Urinator but you must use it within 24 hours.
- Please remember it is always your advantage to start with your fluid sample as close to body temperature as possible.
- As a matter of fact you can even start with a sample warmer than body temperature and The Urinator will not turn itself on until the temperature drops below 98. The Urinator uses a computer chip to digitally lock the temperature in at 98°
- When you have filled The Urinator with the sample example gently squeeze any excess air out of the bag and replace the cap but do not overtighten.
- After each use flush The Urinator out with warm water.
- Do not ever use soap or other cleaning agents to flush The Urinator out.
- Fold the cloth over until the battery holder is exposed install two brand new Duracell batteries.
- It’s very important that you use a new set of batteries each time you take a test.
- Finish folding The Urinator and seal down the ends to make a tight little pack with the tube extending out of one end
- It’s as easy as that.